My smart touch timer5/18/2023 ![]() ![]() You can also use the arrows ( ) to scroll through the options without setting a time. To skip through without setting, simply stop pressing buttons and the display will revert to clock mode after 10 seconds. Repeat these steps for Program 1 Off (“1 OFF”), Program 2 On (“2 ON”), Program 2 Off (“2 OFF”), etc. To go to the next program, use the arrows ( ) and press SET ( ) on the next program you want to set. Use arrows ( ) to select the desired days of the week and press Set ( ). Days of the week will then flash on screen. Use arrows ( ) to select time and press Set ( ). When the “my extra programs” button is pressed “1 ON” will flash on screen but no time will be displayed, only “-:-.” Press Set ( ) to select program “1 on” and the “-:-” will flash on screen. This option offers 7 additional on/off programs. Use arrows ( ) to select the correct day options and press Set ( ). Use arrows ( ) to adjust time (time can be adjusted up to 1 hour in either direction) and press Set ( ). When the “evening ( -12am)” button is pressed, the sunset time will flash on the screen. Use arrows ( ) to select the correct day options and press Set ( ).Įvening Preset: This option will turn the light on at sunset and off at am. Use arrows ( ) to adjust time (time can be adjusted up to hour in either direction) and press Set ( ). Sunrise Off: Press “sunrise off” button and the sunrise time will flash on the screen. Sunset On: Press “sunset on” button and the sunset time will flash on the screen. Select desired off time and press Set ( ). My Off Time: Press “my off time” button and the clock will begin blinking. Use arrows ( ) to select the correct day(s) and press Set ( ). Press “my on time” button and the clock will begin blinking. Note: If the LED next to any button is illuminated, that indicates that the program is active. Choose DST OFF if your local area does not observe Daylight Saving Time. The timer will automatically adjust backwards and forwards an hour. Note: Choose DST ON if your local area observes Daylight Saving Press Set ( ) again to leave DST on or use arrows to change to “OFF” before pressing Set ( ). Press Set ( ) and it will show “ON” on the left of the screen. “DST” (Daylight Saving Time) will flash on screen. ![]() Press Set ( ) and it will show “NOR”, followed by “CENT,” “SOU,” “HI” and “ALAS.” Use arrows ( ) to select correct region (zone) and press Set ( ). Press Set ( ) and it will show “01.” Use arrows ( ) to select current day and press Set ( ). Press Set ( ) and it will show “01.” Use arrows ( ) to select current month and press Set ( ). Press Set ( ) and it will show “2017.” Use arrows ( ) to change year if needed and press Set ( ). Use up ( ) and down ( ) arrows to set current time (take note of AM or PM time) and press Set ( ). To re-enter programming mode, press and hold Set ( ) button for 3 seconds. Note: If no buttons are pressed for 10 seconds during the intial set up of the timer or when setting additional programs, timer will go back to Clock Mode. Once charged, press the reset ( ) button in the lower right corner using a toothpick or pencil. If no numbers are visible on-screen, plug timer into an outlet and let timer charge for 1 hour. MyTouchSmart 35150 2-Outlet Plug-In 7-Day SunSmart Digital Timer - Use Manual - Use Guide PDF. ![]()
0 Comments
Leave a Reply. |